Fortress Foundation Solutions Before & After Photos

This basement in Harrisonburg had water seeping in with rain, so the homeowner reached out to Fortress for a solution to this problem.

Fortress solved this water intrusion issue by installing our WaterGuard System along the perimeter of the home, along with our CleanSpace Wall System, and a TripleSafe sump pump. These products will work together to keep this basement dry!

The crawl space of this home in Rockingham was damp, musty, and needed some help!

Fortress Foundation Solutions went out to this home and installed a complete CleanSpace Encapsulation, along with a SaniDry Sedona Dehumidifier. This crawl space is now a much cleaner and drier space!

This homeowner in Rockingham reached out to Fortress Foundation Solutions because they had a sidewalk that had settled and cracked, becoming quite a tripping hazard!

Fortress was able to resolve this issue by using our PolyLevel Injection System to lift that concrete back up to it's original position. NexusPro Crack Repair was used to seal all cracks.

The basement of this home in Harrisonburg had a recurring problem with water intrusion. The homeowner reached out to Fortress for a permanent solution on how to keep their basement dry.

Our System Designer,Scott Llewellyn, went out to assess this home and determined that the best solution would be to install our WaterGuard XL System along the perimeter of the basement, along with a SuperSump sump pump.

Our WaterGuard System is designed to capture any wall or floor seepage before it reaches the basement floor, any water will then drain to the SuperSump and be pumped out of the home. These products will work together to ensure that this homeowner will no longer have to worry about a wet basement!

This home in Harrisonburg had a sidewalk that was sinking and settling, becoming a tripping hazard.

Our System Designer, Zach Bullock, went out and determined that our PolyLevel Injection System would be able to lift that area back up to it's original position.

The foreman for this, Brian Davis, went out and strategically drilled holes in the concrete where injection ports are then installed. Polyurethane foam is injected beneath the concrete to fill voids and raise the slab. The holes and control joints are then sealed.