Fortress Foundation Solutions Before & After Photos

This home in Herndon had a sidewalk and steps that were sinking and cracking badly.

Our System Designer, Jamey Elder, went out and determined that our PolyLevel Injection System would be able to lift that area back up to it's original position.

The foreman for this, Brian Davis, went out and strategically drilled holes in the concrete where injection ports are then installed. Polyurethane foam is injected beneath the concrete to fill voids and raise the slab. The holes and control joints are then sealed. NexusPro crack repair was used to seal the cracks.

Fortress Foundation Solutions installed a WaterGuard french drain system that connected two rooms, CleanSpace wall system, and TripleSafe sump pump.

This finished basement is being used as a family and recreation room. Fortress Foundation Solutions installed a perimeter french drain system with a TripleSafe sump pump and battery backup.

his home was experiencing main level sagging floors, cracks in the walls, and floors separating from walls. There was also issues with water in the crawlspace, humidity and mold in the home. Upon inspection, we found falling insulation, rotting and moldy joists, and a basic, ineffective plastic sheet on the ground. Fortress Foundation Solutions installed a perimeter TripleSafe sump pump, SaniDry dehumidifer, a total CleanSpace encapsulation, replaced the rotting joists, and installed SmartJacks for a permanent water-free and structurally stable home.

A customer was experiencing water entering the basement and water vapor/humidity issues. Fortress Foundation Solutions installed a full perimeter WaterGuard system with a TripleSafe Sump Pump System to address the water entering the basement. The CleanSpace wall system and Sedona Dehumidification System was added to address the water vapor/moisture issues.