Concrete Leveling Before & After Photos

This home in Troutville had a sidewalk that was sinking and settling. The homeowner reached out to Fortress for a solution to this problem.

Our System Designer, Zach Bullock, went out and determined that our PolyLevel Injection System would be able to lift that area back up to it's original position.

The foreman for this, Brian Davis, went out and strategically drilled holes in the concrete where injection ports are then installed. Polyurethane foam is injected beneath the concrete to fill voids and raise the slab. The holes and control joints are then sealed. 

This homeowner in Rocky Mount, VA called Fortress Foundation Solutions with concerns about the concrete area around their pool. This area needed a little bit of care. The concrete was cracking and was not very pleasant to look at. 

Our System Designer was able to provide an estimate for our Concrete Lifting and Leveling services. 

Our Foreman and his crew were able to use our PolyLevel Injection System to lift all sinking areas. The crew also took care of the cracking by using a sealant. The crew also pressure washed the concrete to clean the dirt off of the area leaving it clean and ready for this summer season!   

Not only is running around the pool dangerous, but uneven concrete is too. It is a tripping hazard that could cause your famaliy to trip and hurt themselves on the concrete. Fortress Foundation Solutions helped make this family's pool safe again. Fortress used the PolyLevel Injection System to level the concrete around the pool. Now the family can play safley. 

This new patio can now have endless dinner parties on it thanks to our team! 

This homeowner in Hardy, VA noticed the concrete slab in the back yard started to sink and crack. The homeowners were looking to get the issue resolved and called Fortress Foundation Solutions for a free estimate. Our System Designer went out to this home and suggested our PolyLevel Injection System. 

Our Forman and his crew began by drilling multiple small holes into the cement of the pad. Once the holes were drilled they began to pump our foam into the holes until the concrete was level. The crew then sealed any cracks with our NexusPro Crack Repair. The final step was to pressure wash the area once the products had dried!